PURE-AIR for Epilog Laser

Keep Your Epilog Running Without a Roof Vent

From the Zing to the Fusion Pro, Epilog machines demand 350-735 CFM of exhaust. PURE-AIR's high-static-pressure extractors deliver that airflow through true H14 + carbon media — recirculating clean air back into your shop, so awards engravers and sign shops can run in strip malls, basements and office parks.

See Compatible Units ↓ Machine Fit Guide

Works with

Zing 16 / 24Fusion Maker / Edge 12-36Fusion Pro 32 / 48

The problems Epilog Laser owners tell us about

Fusion Pro 48 requires up to 735 CFM — most box fans and hobby filters fall far short

Storefront and office locations can't cut holes for exhaust ducting

Engraving anodized aluminum and acrylic all day saturates small carbon filters fast

Real deployments

Fusion Pro 32 (60 W CO2) · PA-FS500

Strip-mall awards shop runs a Fusion Pro with zero ductwork

Challenge: The landlord would not permit exterior wall penetrations, but the Fusion Pro's exhaust requirement is far beyond what hobby-grade filter boxes deliver — acrylic odor was reaching neighboring tenants.

Outcome: Running the FS500 in recirculating mode held visible smoke clearance at the lens carriage even on full-sheet acrylic engraves. The deep carbon bed keeps the sales floor odor-neutral, and quarterly filter swaps take under ten minutes.

Zing 24 (40 W CO2) · PA-FS400 + Replacement Filter Set

Basement engraving business protects living space above

Challenge: Venting through the foundation was not an option, and anodized-aluminum and acrylic jobs were saturating a small hobby filter every few weeks.

Outcome: The FS400's larger carbon mass extended replacement intervals several-fold at the same duty cycle, and the HEPA H14 stage keeps particulate out of the home's shared air.

PURE-AIR extractor

Get Epilog Laser-Specific Pricing

Tell us your exact machine and materials — we'll confirm the right unit, adapter ring and filter stack, with factory-direct pricing, within one business day.

Request a Quote →